IndiaBIX

Computer Science - Computer Hardware

Exercise : Computer Hardware - Section 1
26.
Which part of the laser printer should NOT be exposed to sunlight?
Transfer corona assembly
PC drum
Primary corona wire
Toner cartridge
None of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
27.
After doing a low-level format, what would be the next step in configuring the hard drive in a system?
Format DOS partition
Install operating system
Configure DMA channel and back-up interrupt
Partition had disk
None of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
28.
Resistance is measured in ?
Volts
Amps
Watts
Ohms
None of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
29.
What command is used to reset a MODEM when using the "AT Command Set"?
ATR
ATZ
DTR
DCE
None of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
30.
When installing a SCSI CD-ROM drive, you must set the CD-ROM SCSI adapter to:
B0007
An unused SCSI address
The same address as the SCSI device before the CD-ROM
SCSI ID=1
None of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers