Civil Engineering - Water Supply Engineering - Discussion
Discussion Forum : Water Supply Engineering - Section 3 (Q.No. 5)
5.
For plain chlorination of water, the quantity of chlorine used, is
Discussion:
12 comments Page 1 of 2.
Aadarsh Devkate said:
4 years ago
0.5 to 1 mg/l for plain chlorination.
Heera said:
4 years ago
Super chlorination is the application of chlorine beyond the stage of the break point. It is followed by a contact period of 30-60 minutes.
Heera said:
4 years ago
The normal dose of chlorine during post chlorination is 0.1-0.2ppm.
It is used for protection against contamination.
It is used for protection against contamination.
Heera said:
4 years ago
The normal dose of chlorine during pre chlorination is 0.1 to 0.5 ppm.
This results in the oxidization of organic matter and reduces the amount of coagulants required in the water.
This results in the oxidization of organic matter and reduces the amount of coagulants required in the water.
Heera said:
4 years ago
The normal dose of chlorine during plain chlorination is 0.5-1ppm.
It should be applied when the water is clear and its turbidity does not exceed 30 ppm.
It should be applied when the water is clear and its turbidity does not exceed 30 ppm.
Kebede said:
4 years ago
Thanks all for explaining.
Rixu said:
5 years ago
Plain chlorination - 0.5mg/Lt.
Press chlorination - 0.1-0.5.
Post chlorination - 0.1-0.2.
Press chlorination - 0.1-0.5.
Post chlorination - 0.1-0.2.
Ramu said:
5 years ago
Plain chlorination - 0.5mg/Lt.
Press chlorination - 0.1-0.5.
Post chlorination - 0.1-0.2.
Press chlorination - 0.1-0.5.
Post chlorination - 0.1-0.2.
(1)
Jay solanki said:
5 years ago
For plain, chlorination its a right answer.
Jay solanki said:
5 years ago
And for pre-chlorination, it is 0.1.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers