Civil Engineering - Structural Design Specifications - Discussion
Discussion Forum : Structural Design Specifications - Section 3 (Q.No. 47)
47.
The maximum pitch of rivets for compression and tension members should not exceed
Discussion:
6 comments Page 1 of 1.
Pooja said:
7 years ago
Then, In case of tack riveting?
BIRENDRA said:
5 years ago
Yes, right @Pooja.
Dipu said:
5 years ago
E option is correct only for Tension.
In compression :-12t or 200 mm which is less.
In compression :-12t or 200 mm which is less.
MJM GCEK said:
4 years ago
E is correct for tension in tacking rivets.
Muhammad Nabi said:
3 years ago
For compression 12t or 200 mm.
For tension 16t or 300mm.
Whichever is less in both the cases.
So, The given answer is correct for tension only.
For tension 16t or 300mm.
Whichever is less in both the cases.
So, The given answer is correct for tension only.
(1)
Aryan said:
2 years ago
I think the answer would be 200 mm.
In case of compression 12t or 200mm whichever is less.
In case of tension 16t or 200mm whichever is less.
Here, above the maximum is 200 mm.
In the case of tack rivet 32t or 300mm whichever is less.
In case of compression 12t or 200mm whichever is less.
In case of tension 16t or 200mm whichever is less.
Here, above the maximum is 200 mm.
In the case of tack rivet 32t or 300mm whichever is less.
(2)
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers