Civil Engineering - Steel Structure Design - Discussion
Discussion Forum : Steel Structure Design - Section 1 (Q.No. 9)
9.
According to IS : 800 - 71, the minimum thickness of a vertically stiffened web plate, shall not be less than
none of these.
Discussion:
32 comments Page 2 of 4.
Anomie said:
7 years ago
Yes, right @Pankaj.
PARTHA said:
7 years ago
The answer is fine if you consider the following case as vertical stiffened web plate.
Here min web thickness is concerned so d/250 is the correct answer.
Vertical +1horizontal stiffeners are provided if the web is more than d/200 but less than d/250 (in this case this 1 horizontal stiffener is usual to place at 2/5th of the depth of neutral axis from the compression flange).
Here min web thickness is concerned so d/250 is the correct answer.
Vertical +1horizontal stiffeners are provided if the web is more than d/200 but less than d/250 (in this case this 1 horizontal stiffener is usual to place at 2/5th of the depth of neutral axis from the compression flange).
Sam said:
8 years ago
Option B is the right answer.
Pankaj said:
5 years ago
If the denominator factor is big, the thickness will be small. So if the denominator increases up to 200 thickness decreases to a minimum.
So, answer B. If vertically stiffened assumed. But I think it takes 250 because it hasn't differentiated between horizontal and vertical stiffener.
So, answer B. If vertically stiffened assumed. But I think it takes 250 because it hasn't differentiated between horizontal and vertical stiffener.
Prasad gund said:
5 years ago
According to me , when the d/t is less than 85 then vertically stiffened are not provided but if the value is in between 85 -200 vertically stiffened are provided so the ans is A
Sona college said:
5 years ago
D is the correct answer. Because. They asking only about vertical stiffner they didn't mention whether there is need of hzt stiffner or not.
So, We can take a minimum value.
D/t=250.
T= D * 0.004.
So, We can take a minimum value.
D/t=250.
T= D * 0.004.
Badal kumar said:
3 months ago
Both vertically and horizontally stiffeners are provided for greater than d/200.
Simi said:
8 years ago
Yes, A is the right answer.
Prasenjit said:
8 years ago
According to me, A is correct.
Garry said:
8 years ago
The correct answer is option B.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers