Civil Engineering - Steel Structure Design - Discussion
Discussion Forum : Steel Structure Design - Section 1 (Q.No. 24)
24.
When a tension member is made of four angles with a plate as a web, the allowance for holes is made as
Discussion:
7 comments Page 1 of 1.
Milan said:
9 years ago
Answer must be A.
Sonu said:
8 years ago
Can anyone explain this?
Gohel Hitesh said:
8 years ago
Two rivet holes for each angle and one rivet hole for every 150 mm width of the plate.
Ref:- CIVIL ENGINEERING-Conventional and objective type.
By:- R.S khurmi.
Page no:-622.
Question number:- 258.
Ref:- CIVIL ENGINEERING-Conventional and objective type.
By:- R.S khurmi.
Page no:-622.
Question number:- 258.
Arnab said:
8 years ago
@Gohel Hites.
It is for Four angles forming box section. Not for above scenario.
Answer is Correct.
Ref:- CIVIL ENGINEERING-Conventional and objective type.
By:-R. S khurmi.
It is for Four angles forming box section. Not for above scenario.
Answer is Correct.
Ref:- CIVIL ENGINEERING-Conventional and objective type.
By:-R. S khurmi.
Ft had vb said:
8 years ago
Give an answer is seems to be correct because when 4 angle sections are used at the four sides of a given plate then only single hole is required for each angle section and in the web plate there will be two holes.
Nilraj said:
7 years ago
As using four angles and a plate as web it's become T-section, so answer is correct.
Talib said:
7 years ago
Two holes for each plate and one for angle in box type is correct.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers