Civil Engineering - RCC Structures Design - Discussion
Discussion Forum : RCC Structures Design - Section 2 (Q.No. 9)
9.
The radius of a bar bend to form a hook, should not be less than
Discussion:
29 comments Page 2 of 3.
Nimish gupta said:
5 years ago
(A).Internal r of the hook is 2*dia of bar.
(B).External r of the hook is 3*dia of bar.
Here, it is asked about the minimum r, so(A) is correct.
(B).External r of the hook is 3*dia of bar.
Here, it is asked about the minimum r, so(A) is correct.
Sarang said:
6 years ago
K=2 for mild steel.
K=3 for deformed bar.
K=4 for cold twisted bar.
K=3 for deformed bar.
K=4 for cold twisted bar.
Vetan said:
6 years ago
Internal radius of the bend from hook is (twice the diameter) and the length of straight bar beyond the end of curve should be (seven time the diameter of the bar).
Cigo said:
6 years ago
3d for radius.
4d for straight length beyond that.
4d for straight length beyond that.
Bilal shaikh said:
7 years ago
You are right, Agree @Nayan.
Srinivas said:
10 years ago
Generally 9 times of diameter used for hook.
Alkesh said:
7 years ago
According to me, it is 3.
Akay said:
7 years ago
It is as per the IS code 456:2000.
ANAND said:
7 years ago
Minimum 4 * diameter.
Ashu said:
7 years ago
For mild 2 times
Deformed 4 times
Here the answer is 2 times because mention hook which only formed in mild unless mention specifically HYSd.
Deformed 4 times
Here the answer is 2 times because mention hook which only formed in mild unless mention specifically HYSd.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers