Civil Engineering - Hydraulics - Discussion
Discussion Forum : Hydraulics - Section 2 (Q.No. 40)
40.
In order to avoid capillary correction, the minimum diameter of a manometer used for measuring pressure, should be
Discussion:
9 comments Page 1 of 1.
Jawairia Ghani said:
7 years ago
I think to avoid capillarity action, diameter of manometer should be larger than half inch that is around 12mm.
Dev said:
8 years ago
According to my knowledge, to avoid capillary action min 10mm dia Manometer should be used.
Aadarsh said:
7 years ago
10mm is for spirit level tube.
Here 6mm is for capillary action.
So, Answer is correct.
Here 6mm is for capillary action.
So, Answer is correct.
(2)
Abhishek anand said:
8 years ago
For capillary action, diameter of tube should be less than 30 mm.
Servo said:
6 years ago
It should be greater than 10mm.
(1)
Shai said:
7 years ago
10 mm should be the answer.
Niks said:
5 years ago
4mm is the correct answer.
Sjj said:
7 years ago
10 mm is correct.
Ravindra Maurya said:
8 years ago
Dia<30mm.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers