Chemical Engineering - Process Equipment and Plant Design - Discussion
Discussion Forum : Process Equipment and Plant Design - Section 1 (Q.No. 23)
23.
A rivetted joint does not fail by __________ of rivets.
Discussion:
1 comments Page 1 of 1.
Gaurav. H said:
7 years ago
The answer is C.
Modes of failure in riveted joints can be summarized as:
1) Tearing of the plates between the hole if they are very near to each other.
2) Tearing of plate between the edge of the plate and rivet hole if the hole is too near the edge.
3) Shearing the rivet if the diameter is smaller than necessary.
Modes of failure in riveted joints can be summarized as:
1) Tearing of the plates between the hole if they are very near to each other.
2) Tearing of plate between the edge of the plate and rivet hole if the hole is too near the edge.
3) Shearing the rivet if the diameter is smaller than necessary.
(2)
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers