Chemical Engineering - Process Equipment and Plant Design
Exercise : Process Equipment and Plant Design - Section 1
- Process Equipment and Plant Design - Section 1
- Process Equipment and Plant Design - Section 2
- Process Equipment and Plant Design - Section 3
- Process Equipment and Plant Design - Section 4
- Process Equipment and Plant Design - Section 5
- Process Equipment and Plant Design - Section 6
- Process Equipment and Plant Design - Section 7
- Process Equipment and Plant Design - Section 8
31.
In chemical process equipments, the conical bottom heads used, usually has an apex angle of
32.
Smaller sized packings are generally dumped to the packed columns, and the large ones of size greater than __________ mm are stacked individually, which provides better control over bed porosity and offers lower gas pressure drop.
33.
Shell side heat transfer co-efficient in case of square pitch as compared to the triangular pitch under similar condition of fluid flow and tube size is
34.
Correct use of 'factor of safety' is very important in equipment design. It is defined as the ratio of the
35.
The operating velocity in the absorption tower is usually 40-50% of the flooding velocity. Packed absorption towers are normally designed for a pressure drop of about __________ mm of water column per metre height of packing.
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers