Chemical Engineering - Heat Transfer - Discussion
Discussion Forum : Heat Transfer - Section 4 (Q.No. 36)
36.
For specified tube outside diameter, higher BWG means higher
Discussion:
7 comments Page 1 of 1.
Shan Rana said:
1 decade ago
Exactly @Sherya you are right.
Wall thickness of a tube is normally given by BWG. When gauge numbers is given for a pipe/tube without reference to a system, Birmingham Wire Gauge - BWG - is implied.
Birmingham Wire Gauge is also known as Stubs' Wire Gauge, and also used for drill rod and tool steel wire.
Wall thickness of a tube is normally given by BWG. When gauge numbers is given for a pipe/tube without reference to a system, Birmingham Wire Gauge - BWG - is implied.
Birmingham Wire Gauge is also known as Stubs' Wire Gauge, and also used for drill rod and tool steel wire.
Dehua said:
9 years ago
I think as BWG increases, thickness decreases. In that case cross sectional area will increase. Reverse in case of schedule number.
(1)
Sunil Tiwari said:
8 years ago
Yes, BWG number is inversely proportional to tube wall thickness. Higher the BWG, lower will the thickness.
Shreya said:
1 decade ago
BWG gives wall thickness of pipes. So I think higher BWG should give higher tube thickness.
(1)
Suraj said:
9 years ago
It only measures the thickness hence the thickness increase.
Nandini said:
5 years ago
Yes, you are right @Sunil Tiwari.
(1)
Chandana Devi said:
3 years ago
It should be higher thickness.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers