IndiaBIX

Technical Drawing - Dimensioning

Exercise : Dimensioning - General Questions
11.
Placement of dimensions on a drawing is controlled by ________.
ANSI
The design engineer
Corporate drafting standards
All of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
12.
Baseline dimensions are referenced from a common geometric feature known as a ________.
edge
corner
datum
point of reference
Answer: Option
Explanation:
No answer description is available. Let's discuss.
13.
Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point of crossing?
Use the Modify tool to clean up the extension lines.
Use the Tolerance tool to clean up the extension lines.
Use the Break tool to clean up the extension lines.
Use the stretch tool to clean up the extension lines.
Answer: Option
Explanation:
No answer description is available. Let's discuss.
14.
This is a thin solid line directing attention to a note or dimension and starting with an arrowhead or dot:
Dimension line
Extension line
Leader
Specification
Answer: Option
Explanation:
No answer description is available. Let's discuss.
15.
The maximum and minimum sizes of a feature are identified by a ________ tolerance.
Limits
GD&T
reference
allowance
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers