IndiaBIX

Technical Drawing - Auxiliary Views

Exercise : Auxiliary Views - General Questions
6.
An efficient method for trimming the corners on an auxiliary view is to use the ________.
0 radius fillet
Hatch tool
Extend tool
Grips function
Answer: Option
Explanation:
No answer description is available. Let's discuss.
7.
In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
Primary
Secondary
Revolved
Partial
Answer: Option
Explanation:
No answer description is available. Let's discuss.
8.
When using the descriptive geometry method to create an auxiliary view the drafter should ________.
rotate the snap grid to the same angle of the inclined plane
offset the right vertical line of the front view
rotate the top line of the front view 45 degrees
offset the top line of the front view 2 inches
Answer: Option
Explanation:
No answer description is available. Let's discuss.
9.
This is the most common application for developments and intersections:
Sheet metal construction
Piping
Architecture
Mechanical engineering
Answer: Option
Explanation:
No answer description is available. Let's discuss.
10.
This type of auxiliary view is projected onto a plane that is perpendicular to one of the principal planes of projection:
Primary
Secondary
Revolved
Successive
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers