Placement Papers - L & T

Larsen & Toubro (Engineering Construction & Contracts Division)
L&T ECC PATTERN JULLY - 2007
Posted by :
N.Malathi
(28)
PAPER : L&T ECC PATTERN - July 2007


On 26-07-07, L&T(ECC) came to our college for campus recruiting, besides our college Annamalai university students were also participated in recruitment, The selection process is different for graduates and post graduates,

I am doing M.Tech (electrical), for one hour they conducted test for 60 marks, 30 one mark, 15 two marks, no negative marks. The test was completely based on respective subjects only; they are allowing mechanical, civil, environmental engg students along electrical. The subjects they covered are power systems, power electronics, electrical machines, Electrical measurements, simple logical circuits--

I remembered only few questions
  Convert 26 into binary form  In which gate o/p is 1 when all i/p are 1  What is the 2\'s complement of -17  What is moving coil ammeter reading, if supply is (10+15 sin 314 wt),  If voltmeter reads 100V, if we want to measure 150 what we have to do  Y-delta starter is used for  In a balanced Y connection if VAN=400at 60, what is VBN  for unity TMS 10 sec, what about 0.5 TMS  400V,15 kW,4%slip,50 Hz, 4 pole what is the torque,  what r the factors influencing change in torque &speed  buccholtz relay is used for  lightening arrester is used for  what is the power dissipated in i=10+5 sin 314wt for 2ohm resistor  what should be the impedance value for 3-4j,for max power transfer  if current required for triggering thyristor at -30 degrees(temp) is 80   mA, what is the current required at 60 degrees.  Question regarding thevenins resistance  Question regarding periodic Fourier series  Question regarding reactive power compensation  Question regarding positive sequence currents  400v, 50ohm resistor, inductive reactance 100ohm, circuit to be resonance,   find the voltage across capacitor  what is the ideal power loss for 1.1mH & 11.86 nF, length is   negligible  voltage  sync motor is used for  regarding p.u. values  regarding voltage bus parameters  charging of capacitor  reactive power compensation  Y-bus, Z-bus 2 x 2 matrix  Poles location  I controller is used for