Placement Papers - HAL

HAL Technical Officer Interview Paper (Kolkata)
Posted by :
Hyndavi
(14)
14) In aptitude part see through series completion there was a 5-6 no of that.
15) No aptitude questing like avg, %, proff-loss, prob, etc.
16) Sentence correction 2-3.
17) Why rotor of SCIM is skewed?
18) Magnetostriction increases-
19) Good transformer oil contains how much amount of water in ppm?
20) Lightning over voltage create how much volt?
21) K/s(s+1)(s+5) then find out the value of K so that system become stable.
22) There was a question from definition of Nyquist criteria.
23) Standing done up to the frequency range of? (audio)
24) If a square waveform if given to the supply side of a 2wdg transformer its o/p waveform will be-
25) SC test done on transformer because-
26) If a transformer is operating in .8 PF lag & at efficiency of .9, if now P is .8 lead the efficiency will become.
27) Interpoles are connected for?
28) Dielectric strength of air-
29) A alternator is connected to a grid. Now its prime mover is go slow by ½. Change in its exiting current to held in synchronism.
30) Is the strength of capacitor in LPF is increased the op voltage will-
31) The voltage of a generator and an infinite bus are given 0.92, 10 deg & 1.0, 0 deg resp. the generator acts as a "
32) A wave will not experience any reflection when impedance of line is equal to- surge imp
33) Power transmitted is related to system voltage as-
34) Delay creator ckt name (multivibrator name actually)
35) In tachogenerator adjustment is done by-
36) Surge wave is attended by- (C,L,R)
37) there was 10 question related to measurement-
38) Read all electrostatic instrument related question from any competitive exam book.
39) Lowest reading in moving iron meter is-
40) In galvanometer damping is provided by-
41) In electrodynamic meter a battery & a resistance is provide for-
42) Megger is used for-
43) A question like an ac is applied against a moving coil meter it will reads-
44) Rectifier type instrument measureswhat value - (Rms)
45) Advantage of electrostatic instrument is-
46) Creeping occurs because-
47) Why 2 holes are drilled oppositely in disc of energy meter.
48) Energy meter is a _____ type equipment (recording)
49) There was a question related to selection of a voltmeter based on accuracy-
50) Advantage of hay bridge over anderson bridge-
51) Inductance is measured by " (all the 3 bridge name) .
52) Potentiometer is which type of instrument-
53) Which type of motor is used in refrigerator?
54) Reflection coefficient based problem 1
55) Corona\'s advantage-
15) No aptitude questing like avg, %, proff-loss, prob, etc.
16) Sentence correction 2-3.
17) Why rotor of SCIM is skewed?
18) Magnetostriction increases-
19) Good transformer oil contains how much amount of water in ppm?
20) Lightning over voltage create how much volt?
21) K/s(s+1)(s+5) then find out the value of K so that system become stable.
22) There was a question from definition of Nyquist criteria.
23) Standing done up to the frequency range of? (audio)
24) If a square waveform if given to the supply side of a 2wdg transformer its o/p waveform will be-
25) SC test done on transformer because-
26) If a transformer is operating in .8 PF lag & at efficiency of .9, if now P is .8 lead the efficiency will become.
27) Interpoles are connected for?
28) Dielectric strength of air-
29) A alternator is connected to a grid. Now its prime mover is go slow by ½. Change in its exiting current to held in synchronism.
30) Is the strength of capacitor in LPF is increased the op voltage will-
31) The voltage of a generator and an infinite bus are given 0.92, 10 deg & 1.0, 0 deg resp. the generator acts as a "
32) A wave will not experience any reflection when impedance of line is equal to- surge imp
33) Power transmitted is related to system voltage as-
34) Delay creator ckt name (multivibrator name actually)
35) In tachogenerator adjustment is done by-
36) Surge wave is attended by- (C,L,R)
37) there was 10 question related to measurement-
38) Read all electrostatic instrument related question from any competitive exam book.
39) Lowest reading in moving iron meter is-
40) In galvanometer damping is provided by-
41) In electrodynamic meter a battery & a resistance is provide for-
42) Megger is used for-
43) A question like an ac is applied against a moving coil meter it will reads-
44) Rectifier type instrument measureswhat value - (Rms)
45) Advantage of electrostatic instrument is-
46) Creeping occurs because-
47) Why 2 holes are drilled oppositely in disc of energy meter.
48) Energy meter is a _____ type equipment (recording)
49) There was a question related to selection of a voltmeter based on accuracy-
50) Advantage of hay bridge over anderson bridge-
51) Inductance is measured by " (all the 3 bridge name) .
52) Potentiometer is which type of instrument-
53) Which type of motor is used in refrigerator?
54) Reflection coefficient based problem 1
55) Corona\'s advantage-
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers