Placement Papers - DRDO

Defence Research Development Organisation
DRDO Placement Paper Pattern Part - 1
Posted by :
  Paper : DRDO Placement  Paper Pattern Part - 1     
     Model for ECE:
   Direct Theory question:
   1. A triangular-square wave generator  uses
   * A sine wave oscillator and a  comparator
  * An integrator and a comparator
  * A diffrentiator and comparator
  * A sine wave oscillator and a clipper
   2. An amplifier has two identical  cascaded stages. Each stage has a BW of 20KHz. The overall BW shall be
   * 10KHz
  * 12.9KHz
  * 20KHz
  * 28.3HHz
   Direct numerical problem:
   1. 1. A parabolic dish antenna has a  diameter of 1m. the maximum possible ideal gain of the antenna at a wavelength  3.14cm is
   * 20 dB
  * 30 dB
  * 40 dB
  * 50 dB
   2. 2. The frequency deviation produced  in a VHF carrier by a signal of 100Hz is 50KHz. The frequency modulation is
   100 radians
  250 radians
  500 radians
  750 radians
   Application based theoretical or  numerical problem:
   1. Which one of the pulses has the same  form in time domain as well as in frequency domain
   2. Good voice reproduction via PCM  requires 128 quantization levels. If the BW of voice channel is 4KHz then data  rate is
   256 Kbps
  128 Kbps
  56 Kbps
  28 Kbps 

   3. Match the following:
   1. List 1 List2
  A. Thyristor 1. Second break down
  B. MOSFET 2. Large on-state drop
  C. IGBT 3. Small on state drop
  D. BJT 4. Slow device
   (a) A-4, B-3, C-2, D-1 (b) A-1, B-2,  C-3, D-4
  (c) A-4, B-2, C-3, D-1 (d) A-1, B-3,  C-2, D-4
   4. List 1 List2
  A. Free and forced response 1. Discrete  time systems
  B. Z transform 2. Dirichlet conditions
  C. Probability theory 3. Non-homogenous  differential equation
  d. Fourier series 4. Random process
     (a) A-1, B-3, C-2, D-4 (b) A-3, B-1,  C-2, D-4
  (c) A-1, B-3, C-4, D-2 (d) A-3, B-1,  C-4, D-2
   Assertion and reasoning type:
   The following item consists of two  statements labeled as Assertion A and the other as Reason R. Use the following  codes:
   (a) Both A&R are individually true  and R is the correct explanation of A
  (b) Both A & R are individually true  and R is not the correct explanation of A
  (c) A is true and R is false
  (d) A is false and R is true
   5. Every materials has a different value  of energy band gap except metals which have no band gap
   R The energy band gap is decided by the  equilibrium lattice constant, which is different in different materials.
  6. AOp-amp are commonly used in  instrumentation Op-amps do not load the circuit due to their very high input  impedance