Online Electronics and Communication Engineering Test - Analog Electronics Test 2
Instruction:
- This is a FREE online test. Beware of scammers who ask for money to attend this test.
- Total number of questions: 20.
- Time allotted: 30 minutes.
- Each question carries 1 mark; there are no negative marks.
- DO NOT refresh the page.
- All the best!
Marks : 2/20
Total number of questions
20
Number of answered questions
0
Number of unanswered questions
20
Test Review : View answers and explanation for this test.
1.
An exponential amplifier has diode in feedback path.
Your Answer: Option
(Not Answered)
Correct Answer: Option
Explanation:
It has resistance in feedback path.
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
2.
A 12 kHz pulse wave-form is amplified by a circuit having an Upper cut-off frequency of 1 MHz. The minimum input pulse width that can be accurately reproduced is
Your Answer: Option
(Not Answered)
Correct Answer: Option
Explanation:
tr = 10% Pω =
minimum Power(P) = 10 tr
10 x 0.35 μ sec = 3.5 μ sec.
Note: The I/P Pulse will be severely distorted if the rise time is more than 10% of Pulse width.
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
3.
A transistor with a = 0.9 and ICBO = 10 μA is biased so that IBQ = 90 μA. Then ICQ will be
Your Answer: Option
(Not Answered)
Correct Answer: Option
Explanation:
ICEO = (β + 1)ICBO (9 + 1) 10 μA
100 μA
ICQ = 9 x 90 x 10-6 + 100 x 10-6 = 910 μA.
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
4.
It is desired to reduce distortion in an amplifier from 8% to 2% by using 5% negative feedback. The open and closed loop gains respectively are
Your Answer: Option
(Not Answered)
Correct Answer: Option
Explanation:
.
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
5.
A bridge rectifier circuit has a dc load current of 10 mA and a filter capacitance of 1000 μF. The peak to peak ripple voltage is
Your Answer: Option
(Not Answered)
Correct Answer: Option
Explanation:
Peak to peak ripple voltage = .
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
6.
For an ideal noise free transistor amplifier the noise factor is
Your Answer: Option
(Not Answered)
Correct Answer: Option
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
7.
An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. What percentage of feedback will cause oscillations?
Your Answer: Option
(Not Answered)
Correct Answer: Option
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
8.
Class A and Class B power amplifiers predominate at
Your Answer: Option
(Not Answered)
Correct Answer: Option
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
9.
Which of the following is not valid in case of FETs?
Your Answer: Option
(Not Answered)
Correct Answer: Option
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
10.
In a series regulated power supply circuit the voltage gain of pass transistor satisfies the condition
Your Answer: Option
(Not Answered)
Correct Answer: Option
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
11.
Which of the following configuration has low thermal stability?
Your Answer: Option
(Not Answered)
Correct Answer: Option
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
12.
Occasionally a discrete amplifier user RF chokes instead of collector resistors. Such amplifiers are inherently
Your Answer: Option
(Not Answered)
Correct Answer: Option
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
13.
Examine the circuit of figure and the following statements

- Vs is more than the zener breakdown voltage.
- IL = I1 - I2.
- Rs is less than zener nominal resistance.
Your Answer: Option
(Not Answered)
Correct Answer: Option
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
14.
A capacitor input filter relies on
Your Answer: Option
(Not Answered)
Correct Answer: Option
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
15.
Two identical FETs each having parameters gm and rd are connected is parallel. The composite FET has parameters
Your Answer: Option
(Not Answered)
Correct Answer: Option
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
16.
The main drawback in the performance of shunt peaked wide band amplifier is
Your Answer: Option
(Not Answered)
Correct Answer: Option
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
17.
Which amplifier has the higher power gain?
Your Answer: Option
(Not Answered)
Correct Answer: Option
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
18.
Which class of amplifiers operates with least distortion?
Your Answer: Option
(Not Answered)
Correct Answer: Option
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
19.
For the circuit of figure the input and output Miller resistances are


Your Answer: Option
(Not Answered)
Correct Answer: Option
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
20.
Which of the following statements is false?
Your Answer: Option
(Not Answered)
Correct Answer: Option
Discuss about this problem : Discuss in Forum
Learn more problems on : Analog Electronics
*** END OF THE TEST ***
Time Left: 00:29:56
Post your test result / feedback here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers