Mechanical Engineering - Workshop Technology - Discussion
Discussion Forum : Workshop Technology - Section 2 (Q.No. 19)
19.
In sheet metal work, the cutting force on the tool can be reduced by
Discussion:
26 comments Page 2 of 3.
Md Arbaj said:
7 years ago
Yes, shear angle is the right answer.
Ravi said:
7 years ago
As per my knowledge, the correct answer is C.
Kathiravan said:
8 years ago
The tool end sharp edges then only cut the workpiece.
Manish said:
1 decade ago
What about shear?
Carnot said:
9 years ago
Yes, Answer would be C.
Junaidjamal said:
9 years ago
The right answer is option C.
Neel said:
9 years ago
I too think the answer is C.
S.k.gupta said:
9 years ago
The cutting force on the tool can be reduced by grinding the cutting edge sharp.
S.k.gupta said:
9 years ago
And when load is reduce shear is providing.
Gaurav said:
9 years ago
The correct answer should be C.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers