Mechanical Engineering - Workshop Technology - Discussion
Discussion Forum : Workshop Technology - Section 2 (Q.No. 19)
19.
In sheet metal work, the cutting force on the tool can be reduced by
Discussion:
26 comments Page 2 of 3.
Ravi said:
7 years ago
As per my knowledge, the correct answer is C.
Kathiravan said:
8 years ago
The tool end sharp edges then only cut the workpiece.
Ranjit said:
8 years ago
C is the correct answer.
Carnot said:
8 years ago
Yes, Answer would be C.
Junaidjamal said:
8 years ago
The right answer is option C.
Neel said:
8 years ago
I too think the answer is C.
S.k.gupta said:
9 years ago
And when load is reduce shear is providing.
S.k.gupta said:
9 years ago
The cutting force on the tool can be reduced by grinding the cutting edge sharp.
Gaurav said:
9 years ago
The correct answer should be C.
DIBYARANJAN MAHANTA said:
9 years ago
The right answer is [C] Providing shear on the tool.
So, kindly change the answer to option c.
So, kindly change the answer to option c.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers