Mechanical Engineering - Workshop Technology - Discussion
Discussion Forum : Workshop Technology - Section 3 (Q.No. 25)
25.
The most preferred process for casting gas turbine blades is
Discussion:
33 comments Page 4 of 4.
AMAL said:
10 years ago
Yes it is investment casting because tolerances obtained in it is about 0.05 mm. So nearly correct dimension is obtained and so does not need any further amendment.
RAVI said:
10 years ago
Shell molding is used for cast engine piston and investment casting is for turbine blade.
Nadim said:
10 years ago
Yes it is investment casting.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers