Electronics - Bipolar Junction Transistors (BJT) - Discussion
Discussion Forum : Bipolar Junction Transistors (BJT) - General Questions (Q.No. 12)
12.
The Q point on a load line may be used to determine:
Discussion:
24 comments Page 2 of 3.
Surendran KM said:
8 years ago
I think Q point is the zero signal condition of IC and Vce hence Q pont determine IC and VCE.
V.Nath said:
1 decade ago
Since from load line we get values of Vcc and Ic, so ans is Ic, hence option D is correct.
Ramkamal said:
9 years ago
Ic and Vce denoted by Q point. By the Q point, we determined the value of Ic and Vcr.
Sankalp Gupta said:
8 years ago
We get the value of Ic and Vce due to Q point. Hence option is correct.
HESHMAH said:
9 years ago
Q point represents current gain so, the correct option Ic that means D.
Pradeep sharma said:
8 years ago
The q points are Ic and Vce, not Vb so option X is right.
Firas said:
9 years ago
Vc = Vcc - Vce. Therefore, the answer should be option A.
Sukhpreet said:
1 decade ago
@ Mr. krishn mohan
Vce= Vcc-IcRc not Vb = Vcc-IcRc
Vce= Vcc-IcRc not Vb = Vcc-IcRc
Md.adil said:
1 decade ago
I think answer is wrong it should be Q(vce, ic).
Shrishail said:
1 decade ago
We get Vce & Ic from dc load line not Vb.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers