# Civil Engineering - Structural Design Specifications

### Exercise :: Structural Design Specifications - Section 3

16.

Pick up the correct statement from the following:

 A. The cover of a longitudinal reinforcing bar in a column is kept not less than the diameter of the bar or 40 mm B. The cover of a longitudinal reinforcing bar in beam is kept not less than the diameter of the bar or 25 mm C. The end cover of a longitudinal reinforcing bar in a beam is kept not less than twice the diameter or 25 mm D. The cover for tensile reinforcement in a slab is kept not less than diameter of the bar or 15 mm E. All the above

Explanation:

No answer description available for this question. Let us discuss.

17.

The minimum thickness of the web plate for a crane gantry plate girder with a lifting load exceeding 15 tonnes, is

 A. 4 mm B. 5 mm C. 6 mm D. 8 mm

Explanation:

No answer description available for this question. Let us discuss.

18.

The greater clear dimension of web of thickness't' should not exceed

 A. 180 t B. 200 t C. 240 t D. 270 t

Explanation:

No answer description available for this question. Let us discuss.

19.

The thickness of the rectangular plate for the cap or base of a solid round steel columns, is calculated from the formula where d is

 A. the reduced diameter of the column B. the dimension of the base C. the diameter of the base D. the diameter of the top.

Explanation:

No answer description available for this question. Let us discuss.

20.

For under water concreting.

 A. at least 10 percent more cement is required as compared to dry conditions B. the volume of coarse aggregates shall not be less than one and half times and not more than twice that of fine aggregate C. the slump should not be less than 100 mm and not more than 180 mm D. dewatering by pumping is not done or until 24 hours thereafter E. All the above