Chemical Engineering - Process Equipment and Plant Design
Exercise : Process Equipment and Plant Design - Section 5
- Process Equipment and Plant Design - Section 1
- Process Equipment and Plant Design - Section 2
- Process Equipment and Plant Design - Section 3
- Process Equipment and Plant Design - Section 4
- Process Equipment and Plant Design - Section 5
- Process Equipment and Plant Design - Section 6
- Process Equipment and Plant Design - Section 7
- Process Equipment and Plant Design - Section 8
16.
The thermal stress in a metallic bar does not depend upon the
17.
The minimum baffle height should be
18.
For turbulent flow (NRe > 2100) of low viscosity fluid (μ > 20cp) in steel pipes, the optimum inside pipe diameter is given by(where, Q = fluid flow rate, ft3/sec.ρ = fluid density, lb/ft3 μ = fluid viscosity, centipoise Di = optimum inside pipe diameter, inches)
19.
To avoid the tearing off the plate of an edge, the margin (i.e., the minimum distance from the centre of the rivet hole to the nearest edge of the plate) should be equal to
20.
The normal range of velocity of water in pipes is __________ m/sec.
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers